GTU Modelling And Simulation Techniques - June 2014 Exam Question Paper

GTU Electrical and Electronic Engineering (Semester 8)
Modelling And Simulation Techniques
June 2014

Total marks: --
Total time: --

INSTRUCTIONS
(1) Assume appropriate data and state your reasons
(2) Marks are given to the right of every question
(3) Draw neat diagrams wherever necessary

1 (a) What is the difference between Block Parameters and Tunable Parameters? Explain in details.

7 M

1 (b) List and explain the graphical representation of a block that has states.

7 M

2 (a) Explain the basic elements of Simulink Software.

7 M

Answer any two question from Q2 (b) or Q2 (c)

2 (b) Explain the Model compilation, Simulation loop phase and Link phase in details.

7 M

2 (c) What do you mean by Algebraic loop? Which techniques is used to eliminate the Algebraic loop.

7 M

Answer any two question from Q3 (a), (b) or Q3 (c), (d)

3 (a) Define the following:
i) Block diagram Semantics
ii) Time Step
iii) Block Method
iv) Model Method
v) Block Sample Times
vi) Signals
vii) Custom Block

7 M

3 (b) Explain System and Subsystem.

7 M

3 (c) Draw and explain Triangle Wave Generator model.

7 M

3 (d) Explain Modelling Electronic Component.
a.) Parameterizing an Exponential diode from a Datasheet.

7 M

Answer any two question from Q4 (a), (b) or Q4 (c), (d)

4 (a) Explain which are the components used in Simelectronics libraries.

7 M

4 (b) Explain modelling of continuous system with example.

7 M

4 (c) Explain model of a DC motor driven by a constant input signal that approximates a Pulse-width Modulated signal and look at the current and rotational motion at the motor output.

7 M

4 (d) Explain Runge-Kutta method in details.

7 M

Answer any two question from Q5 (a), (b) or Q5 (c), (d)

5 (a) Formulated to Solve Series RLC Using Resistor Voltage and Inductor voltage with diagram.

7 M

5 (b) Explain the difference between the discrete solver and continuous solver.

7 M

5 (c) Explain the basic steps to use the Simulink software in brief.

7 M

5 (d) Specifying Simulation Accuracy/Speed Trade-off parameters.

7 M

More question papers from Modelling And Simulation Techniques

SPONSORED ADVERTISEMENTS