STUPIDSID
1(a)
State and explain Kirchoff s laws.
5 M
1(b)
Find the currents in the various branches of the given network shown in Fig.Q1(b). !mage
6 M
1(c)
Define the co-efficient of coupling and find its relation with L1,L2 and M.
5 M
2(a)
State ohm's law and mention its limitations.
5 M
2(b)
In the network shown in Fig.Q2(b), find the currents flowing in each branch using Kirchoff s laws.
6 M
2(c)
Define mutual inductance and explain with respect to two coils placed very close to each other.
5 M
3(a)
With neat sketch, explain the construction of the various part of D.C. generator.
5 M
3(b)
What is the significance of back EMF in D.C motor?
5 M
3(c)
With a neat figure, explain the construction and working principle of a dynamometer type wattmeter.
6 M
4(a)
Derive the EMF equation of D.C generator.
5 M
4(b)
Derive an equation for the torque developed in the armature of D.C motor.
5 M
4(c)
With a neat figure, explain the construction and working principle of an induction type single phase energy meter.
6 M
5(a)
Derive an expression for average value of an alternating quantity.
5 M
5(b)
A circuit consists of a resistance of 10Ω,an inductance of 16 mH and a capacitance of 150 muF connected in series. A supply of 100 V at Hz is given to the circuit. Find the current, and power consumed by the circuit. Pf and power consumed by the circuit. Draw the vector diagram. !mage
6 M
5(c)
With a circuit diagram, explain the working of a three way control lamp.
5 M
6(a)
Define RMS value of a simusoidally varying current and find its relation with its maximum value.
5 M
6(b)
Find the total current, power and power factor of the circuit given in Fig.Q6(b).
5 M
6(c)
With a neat figure, explain plate earthing.
6 M
7(a)
In a three phase star connection, find the relation between line and phase values of currents and voltages. Also derive the equation for three phase power.
5 M
7(b)
Show that the two wattmeters are sufficient to measure three phase power. Also derive an expression for the power factor in terms of wattmeter readings.
6 M
7(c)
A 6 pole, 3 phase, star connected alternator has an armature with 90 slots and 12 conductors per shot . It revolves at 1000 rpm, the flux per pole being 0.5 web. Calculate the emf genrated, if the winding factor is 0.97 and all the conductors in each phase are in series. The coil is full pitched.
5 M
8(a)
In a 3 phase delta connection, find the relation between line and phase values of currents and voltage. Also derive an equation for three phase power.
5 M
8(b)
Explain the effect of power factor on the two wattmeter readings connected to measures three phase power.
6 M
8(c)
A 6 pole,3 phase, 50 Hzalternate has 12 slots per pole and 4 conductors per slot. The winding is 5/6 full pitched. A flux of 25 mWb is sinusoidally distributed along the air gap. Determine the line emf, if the alternator is star connected.
5 M
9(a)
Derive the EMF equation of transformer.
5 M
9(b)
Find the numbers of turns on the primary and secondary side of 440/230 V, 50 Hz single phase transformer, if the net area of cross section of the core is 30 cm2and the flux density is 1Wb/m2.
6 M
9(c)
Define the slip of an induction motor and derive the relation between the supply frequency and rotor current frequency.
5 M
10(a)
Explain the different losses occurring in a transformer.
5 M
10(b)
A single phase, 20 KVA transformer has 1000 primary turns and 2500 secondary turns. The net cross sectional area of the core is 100cm2.When the primary winding is connected to 550 V, 50 Hz supply, calculate (i) the maximum value of the flux density in the core.(ii)_The voltage induced in the secondary winding and(iii) the primary and secondary full local currents.
6 M
10(c)
With a circuit diagram,explain the working of a star-delta starter for a three phase induction motor.
5 M
More question papers from Basic Electrical Engg.